Flightcontroller – SP Racing F3_EVO_brush

CHF18.00

SP Racing F3_EVO_brush Flightcontroller
Für die Workshopdrohne

Dimension: about 22mm*32.5mm

Thickness: about 1.2mm
– Base on Openpilot firmware 32 bit brushed flight controller
– Suppot 1S(4.2V),2S(8.4V)Power supply
Independent design of the circuit structure, comes with booster and buck technology, whether it is 1S or 2S power input, the main port has a 5V (PPM / SBUS receiver use) to pass a 3.3V output (DSM / DSM2 / DSM-X receiver Machine use)

innert 1-2 Arbeitstagen

8 vorrätig

Beschreibung

SP Racing F3_EVO_brush Flightcontroller
Für die Workshopdrohne

Dimension: about 22mm*32.5mm

Thickness: about 1.2mm
– Base on Openpilot firmware 32 bit brushed flight controller
– Suppot 1S(4.2V),2S(8.4V)Power supply
Independent design of the circuit structure, comes with booster and buck technology, whether it is 1S or 2S power input, the main port has a 5V (PPM / SBUS receiver use) to pass a 3.3V output (DSM / DSM2 / DSM-X receiver Machine use)
– With large current NMOS tube,working current can be up to 10A
– Support PWM,PPM,SBUS,D SM receiver signal input
– Support coreless motor, include 1020 coreless motor
Receiver configuration as reference:
1. DSM/DSM2/receiver soldered directly to the DSM/DSM2/Receiver interface 3.3V, GND, RX3. Enable Seria_RX for UART3 and Set Receiver mode RX_SERIAL,   Select Spektrum1024(DSM/DSM2) or Spektrum2048() in Raceflight configurator.
2. SBUS receiver welded to the UART1 GND, + 5V, RX1. Then Enable Seria_RX and Set Receiver mode RX_SERIAL , Select Sbus signal in Raceflight configurator.
Attn:
default voltage is 1S(4.2V), pls disconnect the contact for 1S if you need 2S.
Do not short-circuit the three pads at the same time.

Bewertungen

Es gibt noch keine Bewertungen.

Nur angemeldete Kunden, die dieses Produkt gekauft haben, dürfen eine Bewertung abgeben.

Versand der Produkte bis auf weiteres eingestellt, nach Vereinbarung ist abholen weiterhin möglich! 079 825 69 63 ~~~ Grund: Neuer Job und weniger Zeit - don`t f*ck normal life =P Ausblenden